雙組份打膠機的注意事項
由于雙組份密封膠的固化需要一定時間,因此,已涂了雙組份密封膠的玻璃應水平輕輕搬動。
Since the curing of two-component sealant takes a certain time, the glass coated with two-component sealant shall be moved horizontally and gently.
組、b組份膠應保持清潔,嚴防異物進入膠中。
The glue of components a and B shall be kept clean to prevent foreign matters from entering the glue.
在連續工作過程中,膠槍每次停止工作時間一般不得超過20分鐘,否則 中空雙組份打膠機,應用a組份膠沖出全部混合膠,直單一的a組份膠從槍口排出為止。
In the process of continuous operation, the stopping time of the glue gun shall not exceed 20 minutes each time. Otherwise, the hollow two-component glue applicator shall use component a glue to punch out all the mixed glue until a single component a glue is discharged from the muzzle of the gun.
高壓膠管不得---擠壓、彎曲,防止影響系統正常工作。
The high-pressure rubber hose shall not be --- squeezed or bent to prevent affecting the normal operation of the system.
混膠器應經常保持通暢,以良好的出膠效果。如遇堵塞情況,可用---浸泡后清洗。建議每5組清洗一次。
The mixer shall be kept unobstructed frequently to achieve good glue output effect. In case of blockage, it can be cleaned after soaking. It is recommended to clean every 5 groups.
當膠槍長時間不用時(超過一周),應拆下槍體使用溶劑將膠槍和混膠器內的殘留膠體清洗干凈。
When the glue gun is not used for a long time (more than one week), remove the gun body and clean the residual colloid in the glue gun and mixer with solvent.
不同雙組份膠生產廠家所生產的膠內含雜質數量不同,根據實際情況清晰b組分的過濾網及單向止回閥 雙組份打膠機膠槍?zhuān)ㄗh每?jì)山M清洗一次。
The amount of impurities in the glue produced by different two-component glue manufacturers is different. According to the actual situation, the filter screen of component B and the glue gun of one-way check valve two-component glue applicator are clear. It is recommended to clean every two groups.
任何因膠體固化所造成的膠槍、管路或整機的故障 雙組份打膠機配件,一律不在保修范圍之內。
Any failure of glue gun, pipeline or the whole machine caused by colloid solidification, and the accessories of two-component glue applicator are not within the scope of warranty.
定期給各泵的加油口加油,應油霧器內不斷油。
Fill the oil filler of each pump regularly, and keep oil in the oil mist.
上一篇:打膠機跟灌膠機的區別
下一篇:雙組份打膠機怎么更換打膠機通?