雙組份打膠機在使用中應該怎樣維護
雙組份打膠機在使用中應該怎樣維護呢？維護得當，該設備的使用壽命就會(huì )大大延長，反之就會(huì )變短，可能也經常會(huì )有問題。下面小編來講講。
How to maintain the two-component sealant dispenser in use? Properly maintained, the service life of the equipment will be greatly extended, otherwise it will be shorter, and there may be problems frequently. Let's talk about it.
1.由于雙組份打膠機密封膠的固化需要一定的時間，涂有雙組份打膠機密封膠的玻璃應輕輕水平移動。
1. As the curing of two-component sealant requires a certain period of time, the glass coated with two-component sealant shall be gently moved horizontally.
2.雙組份打膠機A組、B組膠應保持清潔，防止異物進入膠內。
2. Group A and B glue of two-component sealant applicator shall be kept clean to prevent foreign matters from entering the glue.
3.在連續工作過程中，膠槍每次工作一般不應停止20分鐘以上，否則，用A組份膠將混合的膠全部沖洗出來，直到單個組份A膠從槍口排出。
3. In the continuous working process, the glue gun shall not be stopped for more than 20 minutes each time, otherwise, the mixed glue shall be washed out with component A glue until the single component A glue is discharged from the gun mouth.
4.不得強行擠壓或彎曲雙組份打膠機的高壓軟管，以免影響系統的正常運行。
4. Do not forcibly squeeze or bend the high-pressure hose of the two-component sealant dispenser, so as not to affect the normal operation of the system.
5.攪膠機應始終保持暢通，以保證出膠效果良好。如有堵塞，可將其浸泡在丙酮中清洗。建議每5組清洗一次。
5. The glue mixer shall always be kept smooth to ensure good glue discharging effect. If there is blockage, soak it in acetone for cleaning. It is recommended to wash every 5 groups.
6.當膠槍長時間不使用時(一周以上)，應將槍體，用溶劑將膠槍和混膠機內殘留的膠水清洗干凈。
6. When the glue gun is not used for a long time (more than one week), the gun body shall be removed, and the glue left in the glue gun and the glue mixer shall be cleaned with solvent.
7.不同雙組份膠廠家生產的膠中雜質含量是不同的。根據實際情況，b組份過濾器和單向閥是否通暢。建議每?jì)山M清洗一次。
7. The content of impurities in the adhesive produced by different two-component adhesive manufacturers is different. According to the actual situation, whether the filter and check valve of component b are smooth. It is recommended to wash every two groups.
8.定期對每個泵的加油口加油，確保注油器內有連續的油。
8. Fill the oil filler of each pump regularly to ensure there is continuous oil in the oil injector.
After knowing the daily maintenance points of the two-component sealant dispenser, I believe you also know how to maintain your two-component sealant dispenser. If you don't know anything, please come to our website http://www.sdxfsljx.com consulting service
上一篇：如何才能保證打膠機的點膠精度？
下一篇：雙組份打膠機在購買前有這些注意事項
